operation manual

33
Mounting
5.1.1 Screw mounting
For the installation with screws and plugs please proceed
as follows:
• Choose a site for installation.
Make sure that no electricity or similar lines run in
the wall at this location!
• Depending on the installation site - wall or cor-
ner - you have to select the corresponding bore
holes on the wall mounting bracket (E) (see fig. 3).
If you want to mount the device to a wall you can
use the bore holes (F), if you want to mount the
device to a corner you can use the bore holes (G).
To be able to use the bore holes (G) you have to
drill trough the holes of the wall mounting brack-
et (E) with a 4 mm drill.
• Position the wall mounting bracket (E) on the
desired site on the wall and mark the bore holes
with a pen.
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5 mm holes to make screws easier
to insert.