operation manual

Restore factory settings
23
7 Restore factory settings
The factory settings of the Access Point can be
restored. This will delete all settings of the en-
tire Homematic IP system. The factory settings
of your Homematic IP devices have to be re-
stored as well.
To restore the factory settings of the Access Point,
please proceed as follows:
• Disconnect the Access Point from the power
supply. Therefore, unplug the mains adapter.
• Plug-in the mains adapter again and press and
hold down the system button for 4s at the
same time, until the LED will quickly start flash-
ing orange.
• Release the system button.
• Press and hold down the system button again
for 4s, until the status LED lights up green. If the
LED lights up red, please try again.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
Permanent
yellow light-
ing
No Internet con-
nection
Please check the
Internet connec-
tion and firewall
settings.
Alternately
long and
short orange
flashing
Update in pro-
gress
Please wait until
the update has
been completed.
Fast red
flashing
Error during
update
Please check
the server and
Internet connec-
tion. Re-start the
Access Point.
Fast orange
flashing
Stage before
restoring the
factory settings
Press and hold
down the system
button again for
4s, until the status
LED lights up
green.
1x long green
lighting
Reset confirmed You can continue
operation.
1x long red
lighting
Reset failed Please try again.