operation manual

22
Mounting
5.2 Screw mounting
For mounting the clip-on frame using screws, please
proceed as follows:
• Choose a site for installation.
Make sure that no electricity or similar lines run in
the wall at this location!
• Position the clip-on frame on the desired site on
the wall.
• Use a pen to mark the positions of the two bore
holes (B) according to the clip-on frame with a
distance of 30 mm on the wall (see fig. 4).
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5mm holes to make screws
easier to insert.
• Use the supplied screws and plugs to fasten the
clip-on frame (see fig. 5).
• Insert the desired Homemaitc IP device (e.g. a
Homematic IP Wall Thermostat) into
the clip-on
frame (see fig. 3). Make sure that the spring latches
(A) are completely latched.