operation manual

31
Hazard information
Do not connect multiple pluggable switches
into one another.
If the dimming actuator is operated with electronic
transformers, only those which meet the
requirements of DIN EN 61347-1 (VDE 0712-30,
Part 1) along with DIN EN 61047 /VDE 0712-25,
Part 2) may be used.
Only dimmable 230 V LED lamps may be used. Not
dimmable 230 V LED lamps may destroy the
device and/or the light source.
Switching on of loads during power-on state
(dimming level unequal to 0) is not permitted.
Doing so may generate very high inrush currents
that can destroy the device.
In order to avoid changes in the level of bright-
ness, the device is able to detect ripple control
signals. However, short-time flickering of the
light source due to ripple control signals cannot
be completely excluded.