operation manual

33
Changing battery
attached to the housing).
• Insert a new 1.5 V LR03/micro/AAA battery into
the battery compartment, making sure that it is
the right way round (see figure 4).
• Close the battery compartment by swinging the
battery compartment cover back on. Push the
cover towards the centre of the housing (apply-
ing a little pressure) until it latches into place.
Once the battery has been inserted, the key ring remote
control performs a self-test (approx. 2 seconds). After-
wards, initialisation is carried out. The LED test display
will indicate that initialisation is complete by lighting up
orange and green
(see sec. „8.5 Error codes and flashing
sequences“ on page 36)
.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries to
excessive heat. Do not short-circuit batteries. Do
-
ing so will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.