operation manual

29
Start-up
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the key ring remote control into your system
and enable it to communicate with other Homematic IP
devices, you must teach-in the device to your Homemat-
ic IP Access Point first.
To teach-in the key ring remote control, please proceed
as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item “Teach-in device”.
• Open the battery compartment (G) at the rear
by pushing the battery compartment cover away
from the device. You will need to apply some
pressure to do this (see figure 2).
• This will open the catch; you can then swing
open the battery compartment cover. The cover
will stay connected to the housing.
• Remove the insulation strip from the battery
compartment (G) of the key ring remote control
to activate the device. Teach-in mode remains
activated for 3 minutes.