operation manual
32
Hazard information
The dimming actuator is only suitable for light
bulbs and high-voltage and low-voltage halogen
lamps with electronic transformers as well as
dimmable LED lamps! Please only connect ohmic
and capacitive lamp loads to the dimming actua-
tor, and no televisions, computers, motors etc.
The dimming actuator contains a thermal cut-o.
Please note that in the event of overheating the
loads will be switched o completely.
Switching on of loads during power-on state (dim-
ming level unequal to 0) is not permitted. Doing so
may generate very high inrush currents that can
destroy the device.
Please note that 230V LED lamps may glow or
flash while they are switched o due to the very
low power consumption.
In order to avoid changes in the level of bright-
ness, the device is able to detect ripple control
signals. However, short-time flickering of the
light source due to ripple control signals cannot
be completely excluded.
The device may only be operated within
residential buildings.