operation manual
30
Hazard information
taken into consideration during planning and set-
up. The device has been designed solely for
operation on a 230 V/50 Hz AC supply. Only
qualified electricians (to VDE 0100) are permitted
to carry out work on the 230 V mains. Applicable
accident prevention regulations must be complied
with whilst such work is being carried out. To avoid
electric shocks from the device, please disconnect
the mains voltage (trip the miniature circuit-
breaker). Non-compliance with the installation
instructions can cause fire or introduce other
hazards.
When connecting to the device terminals, take
the permissible cables and cable cross sections
into account.
Connected loads require sucient insulation.
Before the actuator is connected, remove the
fuse from the fuse box.
The device has not been designed to support
safety disconnection.
Please take the technical data (in particular the
maximum permissible eective installed load of
the dimming actuator and the type of load to be