Instructions

57
Configuration via the HomematicIP Wall Thermostat
7 Configuration via the Homema-
ticIP Wall Thermostat
The Homematic IP Floor Heating Actuator can be
configured via the Homematic IP Wall Thermostat
(HmIP-WTH-2), via the Homematic IP Access Point
together with the smartphone app or via the WebUI
of the Homematic Central Control Unit CCU2/
CCU3.
To configure the floor heating actuator using the wall
thermostat, please proceed as follows:
• Press and hold down the control wheel of the
wall thermostat to open the configuration menu.
• Select the
symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the re-
quired floor heating actuator („FALx“) using the
control wheel.
• Please define if you want to configure the device
parameters (”UnP1/UnP2”) or the channel param-
eters (”ChAn”).
All the settings that are made under “UnP1/UnP2”
will be applied to the entire device. All settings
that are made under “ChAn” will be applied to the
single channels of the device.