operation manual

62
Configuration via the Homematic IP Wall Thermostat
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the
required floor heating actuator using the control
wheel.
• Please define if you want to configure the device
parameters (”UnP1/UnP2”) or the channel param-
eters (”ChAn”).
All the settings that are made under “UnP1/UnP2”
will be applied to the entire device. All settings
that are made under “ChAn” will be applied to the
single channels of the device.
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc. ac-
cording to the following table.
Device parameter UnP1:
Parameter Index Value Meaning
Frost pro-
tection
tempera-
ture
P024 3
4
5
...
16
...
19
20
Frost protection activated
2.0 °C
2.5 °C
...
8.0 °C (default)
...
9.5 °C
10.0 °C