operation manual

53
Start-up
figure 3).
• Use an appropriate drill to make the holes as il-
lustrated.
• Use the supplied screws and plugs to fasten the
floor heating actuator (see fig. 3).
5.2 DIN rail mount
For mounting the floor heating actuator to a DIN rail,
please proceed as follows:
• Place the floor heating actuator onto the DIN rail
(see fig. 4).
• Latch the floor heating actuator by pressing the
spring latches (E) upwards (see fig. 4).
• Make sure that the spring latches are completely
latched and that the device is seated solidly on
the rail.
6 Start-up
6.1 Installation instructions
Please read this entire section before starting to
install the device.
Please note! Only to be installed by persons
with the relevant electro-technical knowledge
and experience!*