operation manual
49
Operation
6 Operation
After teaching-in and mounting have been performed,
simple operations are available directly on the device.
If the radiator thermostat is in standby mode,
please press the control wheel (E) once before
operation to activate the device.
• Temperature: Turn the control wheel (E) to the
right or to the left to manually change the tem-
perature of the radiator. In automatic mode, the
manually set temperature will remain the same
until the next point at which the profile changes.
Afterwards, the defined heating profile will be ac-
tivated again. During manual operation, the tem-
perature remains activated until the next manual
change.
• Manual and automatic mode: Press and hold
down the control wheel (E) to switch between
manual and automatic mode. In automatic mode,
the defined heating profile of the Homematic IP
app is active. In manual operation, the tempera-
ture can be set directly on the device or via the
app and will remain active until the next manual
change.
• Boost function: Press the control wheel (E)
shortly to activate the boost function for heating
up the radiator quickly and briefly by opening the