operation manual

76
Operating modes and configuration
6.10 Configuring the floor heating actuator
You can use this menu item for configuring your Home-
matic IP Floor Heating Actuator.
• Press and hold down the control wheel (E) to
open the configuration menu (see fig. 6).
• Select the
symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the re-
quired floor heating using the control wheel.
• Please define if you want to configure the device
parameters (”UnP1/UnP2”) or the channel param-
eters (”ChAn”).
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc.
For further information regarding the configuration op-
tions, please refer to the user manual of the floor heating
actuator.
6.11 Communication test
You can check the connection between your Homematic
IP Wall Thermostat and the Homematic IP Floor Heating
Actuator. During this test, the wall thermostat transmits
a switching command to the floor heating actuator. De-
pending on the current status of the actuator, the device
is switched on or o for confirmation after receiving the