operation manual

64
Operating modes and configuration
6.7 Date and time
6.8
Oset temperature
6.9
Selecting the desired temperature
display
6.10
Configuring the floor heating actuator
6.11
Communication test
6.1 Automatic mode
In automatic mode, the temperature is controlled in
accordance with the set week profile (see „6.6.3 Week
profile“ on page 73). Manual changes that are set via
the control wheel (E) are activated until the next point at
which the profile changes. Afterwards, the defined heat-
ing profile will be activated again. To activate the auto-
matic mode, please proceed as follows:
• Press and hold down the control wheel (E) to
open the configuration menu (see fig. 6).
• Select the
symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.