operation manual
60
Start-up
If the wall thermostat is operated stand-alone (without
further Homematic IP components), please continue to
chapter 6.
5.4 Teaching-in
Please read this entire section before starting
the teach-in procedure.
To integrate the wall thermostat into your system and
enable it to communicate with other devices, you must
teach it in first.
You can either pair the wall thermostat directly with the
Homematic IP Floor Heating Actuator for controlling
your floor heating system or teach it in to the Homematic
IP Access Point for controlling the room climate in every
room. After pairing, configuration has to be done directly
on the device. After teaching-in to the Access Point, con-
figuration is done via the Homematic IP app.
5.4.1 Pairing with a Homematic IP Floor Heating
Actuator
Please make sure you maintain a distance of at
least 50cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (D) again. This will be
indicated by the device LED (D) lighting up red.