operation manual

41
Start-up
• Place the clip-on frame (A) onto the voltage
supply unit (see fig. 3). Alternatively, you can
continue using your existing frame with an inner
dimension of 55 mm.
• Place the electronic unit of the push-button (B)
into the clip-on frame so that the contact of the
electronic unit latches into the voltage supply
unit (see figure 4).
• Switch the circuit breaker of the power circuit
back on again.
• The switch actuator starts its operation and can
be connected to the Homematic IP Access Point
(see “5.3 Teaching-in” on page 41).
5.3 Teaching-in
Please read this entire section before starting
the teach-in procedure.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2/CCU3. For detailed information about
teach-in or configuration via a control unit,
please refer to the Homematic IP User Guide,
available for download in the download area of
www.eQ-3.com.