operation manual

47
Start-up
Step 1 Switch o the fuse of the power circuit
(see “6.1 Installation instructions” on page
44).
Step 2 If necessary, pull the rocker o the frame
of the relevant switch. Then pull the
frame o the switch together with the
clamping/retaining piece. The clamping/
retaining piece can be transparent, grey
or black depending on the manufacturer,
and holds the frame onto the switch.
To make removal easier, a flat, pointed
object such as a slotted screwdriver can
be used.
Step 3 Release the wiring and remove the exist-
ing switch if necessary.
Step 4 Connect the switched phase conductors
for connecting terminals 1 and 2 to the
motor as follows (see fig. 2):
Connecting terminal 1
(C): “Down”
Connecting terminal 2
(D): “Up”
Step 5 Connect the phase conductor to
connecting terminal L (B) .
Step 6 Connect the neutral conductor to
connecting terminal N (E) .