operation manual

46
Start-up
Installation may only take place in normal com-
mercial switch boxes (device boxes) in accord-
ance with DIN 49073-1.
The device may only be operated with adapters
and an associated, fitted switch cover. The switch
cover may only be removed during configuration.
Please observe the hazard information in section
“2 Hazard information” on page 34 during in
-
stallation.
Permitted cable cross sections for connecting to the
shutter actuator are:
rigid cable
[mm
2
]
flexible cable with/without ferrule
[mm
2
]
0.75 – 1.50 0.75 – 1.50
6.2 Installation
You can use the shutter actuator in a shutter or awning
circuit (see fig. 2). To install the shutter actuator, please
proceed as follows: