operation manual

50
Restore factory settings
1x orange and 1
x green lighting
Test display Once the test
display has stopped,
you can continue.
8 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the wall-mount remote
control, please proceed as follows:
• Remove the rocker if required (see fig. 4).
• Press and hold down the system button (A) for 4
seconds with a pointed object (e.g. a pen) until the
LED (A) starts flashing orange quickly (see fig. 5).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.