operation manual

45
Start-up
Step 4 Release the wiring and remove the exist-
ing switch if necessary.
Step 5 Connect the phase conductor to con-
necting terminal L (B) (see fig. 2).
Step 6 Connect the neutral conductor to con-
necting terminal N (C) (see fig. 2).
Step 7 Secure the wall-mount remote control
using the provided screws into the
flush-mounted box. Please note that the
system button (A) of the actuator must be
at the top left during installation.
Step 8 Fit the adapter to the rocker (see fig. 3).
Step 9 Now secure the rocker with the adapter
in the frame on the actuator.
Position the adapter so that both latching
lugs fit into the existing elongated holes
(see fig. 6).
Step 10 Switch the circuit breaker of the power
circuit back on again.
Step 11 Now, the wall-mount remote control
can be connected to the Homematic IP
Access Point (see “11.1 Teaching-in” on
page <ÜS>).