operation manual

44
Start-up
Permitted cable cross sections for connecting to the
wall-mount remote control are:
rigid cable [mm
2
] flexible cable with/without
ferrule [mm
2
]
0.75 – 1.50 0.75 – 1.50
6.2 Installation
To install the wall-mount remote control, please proceed
as follows:
Step 1 Switch o the circuit breaker of the
power circuit.
Step 2 If necessary, pull the rocker o the frame
of the relevant switch. Then pull the
frame o the switch together with the
clamping/retaining piece. The clamping/
retaining piece can be transparent, grey
or black depending on the manufacturer,
and holds the frame onto the switch.
To make removal easier, a flat, pointed
object such as a slotted screwdriver can
be used.
Step 3 Loosen the fastening of the existing
switch and carefully remove it from the
flush-mounted box.