operation manual

47
Start-up
Permitted cable cross sections for connecting to the
dimming actuator are:
rigid cable
[mm
2
]
flexible cable with/without ferrule
[mm
2
]
0.75 – 1.50 0.75 – 1.50
6.2 Installation
You can use the dimming actuator (see fig. 3) in a dim-
ming circuit:
To install the dimming actuator, please proceed as
follows:
Step 1 Switch o the fuse of the power circuit.
Step 2 If necessary, pull the rocker o the frame
of the relevant switch. Then pull the
frame o the switch together with the
clamping/retaining piece. The clamping/
retaining piece can be transparent, grey
or black depending on the manufacturer,
and holds the frame onto the switch.
To make removal easier, a flat, pointed
object such as a slotted screwdriver can
be used.