User manual
48
Start-up
Step 11 Switch the fuse of the power circuit back
on again.
Step 12 Now the blind actuator can be taught-in
to the Homematic IP Access Point (see “7.3
Teaching-in” on page <ÜS>).
6.3 Teaching-in
Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2. For detailed information, please refer to
the Homematic IP User Guide, available for down
-
load in the download area of www.eQ-3.de.
To integrate the blind actuator into your system and enable
it to communicate with other Homematic IP devices, you
must teach-in the device to your HomematicIP Access
Point first.