Instruction Manual

Start-up

7.4 Teaching-in devices to the CCU3

Please read this entire section before starting

the teach-in procedure.

Your Homematic and Homematic IP device can be

conveniently controlled and conﬁgured or used in Central

Control Unit programs using a software-based method.

Therefore, they must be integrated into the system via the

WebUI. To do this, please proceed as follows:

• Start the WebUI user interface in the web browser

of your PC.

• Click the “Teach-in devices” button on the right-

hand side of the screen.

• To activate teach-in mode of the CCU3, click

on the desired teach-in window (e.g. “Teach-in

HmIP device”). The teach-in mode of the Central

Control Unit will be activated. An information box

shows how much teach-in time remains.

• Activate the teach-in mode of the device, that you

want to teach in. Please refer to the user manuals

of the corresponding devices for further informa

tion.

• Please wait until teach-in is completed.

• If teaching-in was successful, the LED lights up

green. If the LED lights up red, please try again.

• After a short time, the newly connected device

appears in the inbox of your WebUI.

Newly connected devices and the corresponding chan-

nels are ready for operation and conﬁguration only after

they have been conﬁgured in the inbox. You will ﬁnd fur-

ther information in the Homematic WebUI Manual, avail-

able for download at www.eQ-3.com.