Instructions

45
Start-up
the bracket) (see figure 11). Depending on the
condition of the surface you can choose between
four screw holes.
• Drill the marked holes (see fig. 11).
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are using a wooden wall, you can
pre-drill 1.5 mm holes to make screws easier to
insert.
• Use the supplied screws and plugs to fasten the
mounting bracket (see figure 12 or 13).
• If necessary, lead the cable of the power supply
unit through the cable opening of the mounting
bracket.
• Place the device first on the upper and then on
the lower lugs of the mounted wall bracket until
it is fully engaged (see figure 12 or 13).
5.4.2 Mounting on a round object
To attach the rain sensor to a round object (e.g. a stainless
steel pipe), you can use the 45 degree bracket (F) and the
included cable ties.
• Lead the cable ties trough the openings provided
in the 45 degree bracket (see figure 14).
• Hold the bracket to the object to which you want
to attach it.