Instructions

Start-up

sary, personal safety equipment;

• Evaluation of measuring results;

• Selection of electrical installation material for safeguard-

ing shut-o conditions;

• IP protection types;

• Installation of electrical installation material;

• Type of supply network (TN system, IT system, TT sys-

tem) and the resulting connecting conditions (classical

zero balancing, protective earthing, required additional

measures etc.).

Please observe the hazard information in section

“2 Hazard information” on page 38 during in-

stallation.

Please note the insulation stripping length of the

conductor to be connected, indicated on the

device.

Permitted cable cross sections for connecting to the

blind actuator are:

rigid cable [mm

]

ﬂexible cable without ferrule [mm

]

0.75 – 2.50 0.75 – 2.50

5.2 Mounting and installation

Please read this entire section before starting to

install the device.

To install the blind actuator on a DIN rail within a

distribution board, please proceed as follows: