User manual

38
Maintenance and cleaning
• Release the system button to finish restoring of the factory set-
tings.
The system LED stops flashing and the device performs a restart. After
the restart, you can again integrate your device into your Homematic IP
system.
10 Maintenance and cleaning
10.1 General information
This device does not require you to carry out any maintenance
other than replacing the battery and cleaning the device when
necessary. Enlist the help of an expert to carry out any mainte-
nance or repairs.
The weather sensor will need to be cleaned from time to time to re-
move the dirt that will accumulate on it. When you do this, you should
also check that the wind sensor can move easily and that the sensors are
properly seated on their supports.
Clean the product using a soft, lint-free cloth that is clean and dry. You
may dampen the cloth a little with lukewarm water in order to remove
more stubborn marks. Make sure that no moisture will ingress into the
housing. Do not use any detergents containing solvents, as they could
corrode the plastic housing and label.
Check that your product is safe from a technical point of view
(that the housing is not damaged, for example) on a regular basis.
If you have reason to believe that it is no longer safe to operate