User manual

33
Teaching-in
First set up your Homematic IP Access Point via the Homematic
IP app to enable operation of other Homematic IP devices within
your system. For further information, please refer to the operat-
ing manual of the Access Point.
You can connect the device either to the Access Point or to the
Homematic Central Control Unit CCU2. For detailed information,
please refer to the Homematic IP User Guide, available for down-
load in the download area of www.eQ-3.de.
To teach-in the weather sensor to the Access Point, please proceed as
follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item “Teach-in device”.
• Loosen the cover of the main sensor (E) by turning the cylinder
clockwise and pulling it downwards.
• Remove the insulation strip from the battery compartment (J) to
activate the teach-in mode. The system LED (H) starts flashing.
Pairing mode remains activated for 3 minutes.
You can manually start the teach-in mode for another 3 minutes
by pressing the system button (I) briefly using a pointed object
(see figure 3).
• Your device will automatically appear in the Homematic IP app.
• To confirm, please enter the last four digits of the device number
(SGTIN) in your app or scan the QR code. Therefore, please see
the sticker supplied or attached to the device.
• Please wait until teach-in is completed.