User manual

Teaching-in

Step 3:

• Remove the pipes of the stainless steel mast (G) from the pack-

aging.

• Join the pipes together. The previously assembled weather sen-

sor is ﬁxed to the end of the pipe that is marked with a sticker.

• Place the fully assembled sensor within the potential transmis-

sion radius (up to 400 m typically in the open air, with damping

caused by building walls taken into account). Choose a free posi-

tion in which it is possible for rain to fall directly into the rain sen-

sor, but where there is no risk of inaccurate wind measurements

caused by nearby buildings, trees, etc.

It may be placed in a sunny location since the temperature sen-

sor is located in a shaded, ventilated area of the housing.

• Push the assembled end of the stainless steel mast (G) into the

ground until you are sure that the sensor will be stable.

If the weather sensor topples over, it may cause injury or damage

to vehicles and objects.

6 Teaching-in

Please read this entire section before starting the teach-in pro-

cedure.