Instructions

37
Restore factory settings
1x long red light-
ing
Transmission failed
or duty cycle limit is
reached
Please try again (see sec.
„8.2 Command not con-
firmed“ on page 35 or
„8.3 Duty cycle“ on page
36).
Short orange
flashing (every
10 s)
Teach-in mode active Please enter the last four
numbers of the device serial
number to confirm (see „6
Teaching-in“ on page 32).
Short orange
lighting (after
green or red
confirmation)
Batteries empty Replace the batteries of the
device (see „7 Replacing
batteries“ on page 34).
6x long red
flashing
Device defective Please see your app for er-
ror message or contact your
retailer.
1x orange and 1 x
green lighting
Test display/
system start
Once the test display has
stopped, you can continue.
9 Restore factory settings
The factory settings of the device can be restored. If you do this,
you will lose all your settings.
To restore the factory settings of the weather sensor, please proceed as
follows:
• Loosen the cover of the main sensor (E) by turning the cylinder
clockwise and pulling it downwards.
• Press and hold down the system button (I) using a pointed ob-
ject, e.g. a pen (see fig. 3) until the system LED (H) slowly starts
flashing orange.
• Press and hold down the system button again until the system
LED starts quickly flashing orange.