Instructions

34
Replacing batteries
• If teaching-in was successful, the system LED lights up green.
The device is now ready for use.
• If the system LED lights up red, please try again.
• In the app, give the device a name and allocate it to a room.
• Slide the cover from the bottom onto the main sensor and latch
it into place by turning it anti-clockwise.
7 Replacing batteries
If an empty battery is displayed via the app or the device (see „8.4 Error
codes and flashing sequences“ on page 36), replace the used batteries
by three new LR6/mignon/AA batteries. You must observe the correct
battery polarity.
To replace the batteries of the weather sensor, please proceed as follows:
• Loosen the cover of the main sensor (E) by turning the cylinder
clockwise and pulling it downwards.
• Remove the empty batteries from the battery compartment (J).
• Insert three new 1.5 V LR6/mignon/AA batteries into the battery
compartment (J), making sure that you insert them the right way
round (see figure 4).
• Close the housing again by pushing and turning the cylinder
clockwise until it latches into place.
Once the batteries have been inserted, the weather sensor will perform a
self-test (approx. 2 seconds). Afterwards, initialisation is carried out. The
LED test display will indicate that initialisation is complete as the system
LED (H) lights up orange and green.