User manual

45
Maintenance and cleaning
To restore the factory settings of the wall-mount remote
control, please proceed as follows:
• Remove the rocker if required (see fig. 4).
• Press and hold down the system button (A) for 4
seconds with a pointed object (e.g. a pen) until the
LED (A) starts flashing orange quickly (see fig. 5).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
9 Maintenance and cleaning
The product does not require any maintenance.
Enlist the help of an expert to carry out any main-
tenance or repairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. You may dampen the cloth a little with lukewarm
water in order to remove more stubborn marks. Make
sure that no moisture will ingress into the housing. Do
not use any detergents containing solvents, as they could
corrode the plastic housing and label.