User manual

42
Replacing batteries
To replace the batteries of the weather sensor, please proceed as follows:
• Loosen the cover of the main sensor (G) by turning the cylinder
clockwise and pulling it downwards.
• Remove the empty batteries from the battery compartment (L).
• Insert three new 1.5 V LR6/mignon/AA batteries into the battery
compartment, making sure that you insert them the right way
round (see figure 3).
• Close the housing again by pushing and turning the cylinder
clockwise until it latches into place.
Once the batteries have been inserted, the weather sensor will perform a
self-test (approx. 2 seconds). Afterwards, initialisation is carried out. The
LED test display will indicate that initialisation is complete as the system
LED (J) lights up orange and green.
Caution! There is a risk of explosion if the battery is not replaced
correctly. Replace only with the same or equivalent type. Never
recharge standard batteries. Do not throw the batteries into a fire.
Do not expose batteries to excessive heat. Do not short-circuit
batteries. Doing so will present a risk of explosion.
Used batteries should not be disposed of with regular domestic
waste! Instead, take them to your local battery disposal point.