User manual

40
First start-up
• Remove the insulation strip from the battery compartment (L) to
activate the teach-in mode. The system LED (J) starts flashing.
Pairing mode remains activated for 3 minutes.
You can manually start the teach-in mode for another 3 minutes
by pressing the system LED (J) briefly using a pointed object (see
figure 4).
• Your device will automatically appear in the Homematic IP app.
• To confirm, please enter the last four digits of the device number
(SGTIN) in your app or scan the QR code. Therefore, please see
the sticker supplied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the system LED lights up green.
The device is now ready for use.
• If the system LED lights up red, please try again.
• In the app, give the device a name and allocate it to a room.
• Slide the cover from the bottom onto the main sensor and latch
it into place by turning it anti-clockwise.
6.2 Alignment of the weathervane
To enable the definition of the wind direction, the weather sensor must
be aligned during the first set-up so that it is pointing north. To do this,
please proceed as follows:
• Align the weathervane (E) of the weather sensor so that it is
pointing north. Therefore, we recommend to use an analogue or
electronic compass.