User manual

Mounting

In doing so, ensure that the positions of the cover drain hole and

the sensor support line up (the housing drain hole should be fac-

ing outwards).

Step 4:

• Remove the pipes of the stainless steel mast (I) from the pack-

aging.

• Join the pipes together. The previously assembled weather sen-

sor is ﬁxed to the end of the pipe that is marked with a sticker.

• Place the fully assembled sensor within the potential transmis-

sion radius (up to 400 m typically in the open air, with damping

caused by building walls taken into account). Choose a free posi-

tion in which it is possible for rain to fall directly into the rain sen-

sor, but where there is no risk of inaccurate wind measurements

caused by nearby buildings, trees, etc.

It may be placed in a sunny location since the temperature sen-

sor is located in a shaded, ventilated area of the housing.