User manual
32
Mounting
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5mm holes to make screws
easier to insert.
• Use the supplied screws and plugs (L) to fasten
the mounting plate to the wall (see figure 4).
• Attach the clip-on frame (A) to the mounting
plate.
• Place the electronic unit (B) back into the frame
(see figure 1). Make sure that the clips on the
mounting plate latch into the openings on the
electronic unit.
Information about installation on flush-mounted
boxes:
• For installation on a flush-mounted box, please
use the bore holes (K) (see fig. 3)
Please note! Only to be installed by persons with
the relevant electro-technical knowledge and
experience!*
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical system.