User manual

27
Start-up
• Remove the insulation strip from the battery
compartment (B) of the light sensor to activate
the device. Pairing mode remains activated for
3 minutes.
You can manually start the teach-in mode for
another 3 minutes by pressing the system button
(C) shortly (see figure 5).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of
the device number (SGTIN) in your app or scan
the QR code. Therefore, please see the sticker
supplied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the device LED (C)
lights up green. The device is now ready for use.
If the device LED (C) lights up red, please try
again.
• Please select in the app, in which application
(e.g. light and/or climate control) you would like
to use the device.
• Allocate the device to a room and give the
device a name.