User manual

25
Mounting
The mounting location should be protected
from the eects of weather.
5.2 Wall mounting
For the wall mounting with the supplied screws and
plugs please proceed as follows:
• Choose a site for installation (see “5.1 General
notes on installation” on page 24).
• Remove the cap (A) (see fig. 2).
• Position the light sensor without cap (A) at the
desired location site and mark the bore holes (E)
with a pen (see fig. 3).
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.
• Insert the plugs into the bore holes.
• Position the light sensor and insert the screws
(see fig. 4).
• Do not yet place the cap (A).