User manual

35
Start-up
Installation may only take place in normal
commercial switch boxes (device boxes) in
accordance with DIN 49073-1 or surface-
mounting boxes in accordance with DIN 60670-1
(e.g. Abox 025 or Abox 040).
Please observe the hazard information in section
„2 Hazard information“ on page 24 during in
-
stallation.
Permitted cable cross sections for connecting to the
blind actuator are:
rigid cable [mm
2
] flexible cable with/without ferrule
[mm
2
]
0.75 - 1.50 0.75 - 1.50
5.2 Installation
You can install the blind actuator
• in a flush-mounting box or
• in a surface-mounting box
5.2.1 Flush-mounting box installation
To install the blind actuator in a flush-mounting box,
please proceed as follows:
• Switch o the fuse of the power circuit.
• Connect the switched phase conductors for con-