Instructions
41
Start-up
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5mm holes to make screws easier
to insert.
• Use the supplied screws and plugs to fasten the
garage door controller (see fig. 7).
• Reattach the cover.
• Switch the power circuit on again to activate the
teach-in mode of the device (see following sec-
tion).
5.3 Teaching-in
Please read this entire section before starting
the teach-in procedure.
To integrate the garage door controller into your system
and enable it to communicate with other devices, you
must teach it in first.
5.3.1 Teaching-in to the Homematic IP Access Point
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.