User manual
25
Mounting
When selecting a mounting location and drilling
in the vicinity of switches or socket outlets,
check for electrical wires and power supply
cables.
The mounting location should be protected
from the eects of the weather and not exposed
to direct sunlight or other sources of heat
radiation.
5.2 Wall mounting
For the wall mounting with the supplied screws and
plugs, please proceed as follows:
• Choose a site for installation (see “5.1 General
notes on installation” on page 24).
• Remove the cap (A)
(see fig. 2)
.
• Position the temperature and humidity sensor
without cap (A) on the desired site on the wall
and mark the bore holes (D) with a pen (
see fig. 3)
.
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.