User manual
33
Start-up
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5mm holes to make screws easier
to insert.
• Use the supplied screws and plugs (J) to fasten
the mounting plate to the wall (see figure 6).
• Attach the clip-on frame (A) to the mounting
plate.
• Place the sensor (B) back into the frame (see fig-
ure 1). Make sure that the clips on the mounting
plate latch into the openings on the sensor.
5.2.3 Mounting on flush-mounted boxes
You can mount the temperature and humidity sensor on
flush-mounting/installation boxes using the holes (H)
(see figure 4).
If the device is mounted to a flush-mounting box,
there may be no open conductor ends.
If changes or works have to be made on the house
installation (e.g. extension, bypass of switch- or
socket inserts) or the low-voltage distribution for
mounting or installing the device, the following
safety instruction must be considered: