User manual

30
Start-up
• Open the Homematic IP app on your smartphone.
• Select the menu item “Teach-in device”.
• To remove the sensor (B) from the frame, take
hold of the sides of the sensor and pull it out (see
figure 2).
• Turn over the sensor.
• Remove the insulation strip from the battery
compartment. Teach-in mode remains activated
for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button
(D) briefly (see figure 3).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Please select, in which application (e.g. climate
control) you would like to use the device.
• Allocate the device to a room and give the device
a name.