User manual

69
Manual operation
ton (B) (see fig. 7) .
• Press the select button until the LED (B) flashes
green three times.
The channel will be switched on or o for 15 minutes.
Afterwards, normal operation will be continued for the
heating zone.
8.2 Activating/deactivating the pump control
If you want to use connection terminal (F) for controlling
a heating pump, the heating zone can be switched to
pump control directly via the device. To do this, proceed
as follows:
• Press the select button (B) until the LED of
channel 1 starts flashing green
(see fig. 7) .
If the LED of channel 1 starts flashing slowly, the
pump control is activated. If the LED of channel 1 starts
flashing quickly, the pump control is deactivated.
• If you do not want to change any parameters, you
can exit the menu by pressing the select button
(B) briefly.
• To switch the parameter from activated to de-
activated or from deactivated to activated, press
and hold down the select button (B) for at least
4 seconds.