User manual

52
Start-up
• Latch the floor heating actuator by pressing the
spring latches (E) upwards (see fig. 3).
• Make sure that the spring latches are completely
latched and that the device is seated solidly on
the rail.
• Place the transformer next to the floor heating
actuator onto the DIN rail (see fig. 4).
• Latch the transformer by pressing the spring latch
upwards (see fig. 4).
• Make sure that the spring latch engages properly
and that the device is securely seated on the rail.
6 Start-up
6.1 Installation instructions
Please read this entire section before starting to
install the device.
Please note! Only to be installed by persons
with the relevant electro-technical knowledge
and experience!*
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical sys-
tem.