User manual

52
Troubleshooting
During normal operation, the duty cycle is not usually reached. However,
repeated and radio-intensive teach-in processes mean that it may be
reached in isolated instances during start-up or initial installation of
a system. If the duty cycle is exceeded, this is indicated by three long
flashes of the device LED, and may manifest itself in the device temporarily
working incorrectly. The device starts working correctly again after a
short period (max. 1 hour).
10.3 Error codes and flashing sequences
10.3.1 Flashing sequences of the system LED (A)
Flashing code Meaning Solution
Short orange
flashing
Radio transmission/
attempting to trans-
mit/data transmission
Wait until the transmission is
completed.
1x long green
lighting
Transmission con-
firmed
You can continue operation.
1x long red
lighting
Transmission failed Please try again (s. „10.1
Command not confirmed“
on page 51).
Short orange
flashing (every
10 s)
Teach-in mode active Please enter the last four
numbers of the device serial
number to confirm (see „6.4
Teaching-in“ on page 40).
1x long red
lighting
Transmission failed
or duty cycle limit is
reached
Please try again (see sec. „10.1
Command not confirmed“
on page 51 or „10.2 Duty
cycle“ on page 51).
6x long red
flashing
Device defective Please see your app for
error message or contact
your retailer.
1x orange and 1 x
green lighting
Test display Once the test display has
stopped, you can continue.