User manual

50
Delete device connections
• Press the select button until the LED (B) flashes green three times.
The channel will be switched on or o for 15 minutes. Afterwards, normal
operation will be continued for the heating zone.
8.2 Activating/deactivating the pump control
If you want to use connection terminal (F) for controlling a heating pump,
the heating zone can be switched to pump control directly via the device.
To do this, proceed as follows:
• Press the select button (B) until the LED of channel 1 starts flash-
ing green (see fig. 7).
If the LED of channel 1 starts flashing slowly, the pump control is
activated. If the LED of channel 1 starts flashing quickly, the pump
control is deactivated.
• If you do not want to change any parameters, you can exit the
menu by pressing the select button (B) briefly.
• To switch the parameter from activated to deactivated or from
deactivated to activated, press and hold down the select button
(B) for at least 4 seconds.
9 Delete device connections
To delete the device connections between the floor heating actuator and
the wall thermostat, please proceed as follows:
• Select the channel of the floor heating actuator to which the wall
thermostat is connected using the select button (B) (see fig. 7).