User manual

45
Configuration via the Homematic IP Wall Thermostat
7 Configuration via the Homematic IP Wall
Thermostat
The Homematic IP Floor Heating Actuator can be configured via
the Homematic IP Wall Thermostat (HmIP-WTH-2), via the
Homematic IP Access Point together with the smartphone app or
via the WebUI of the Homematic Central Control Unit CCU2.
To configure the floor heating actuator using the wall thermostat, please
proceed as follows:
• Press and hold down the control wheel of the wall thermostat to
open the configuration menu.
• Select the symbol by turning the control wheel and confirm
by pressing the control wheel briefly.
• If the wall thermostat is connected to more than one floor heat-
ing actuator, please select the required floor heating actuator us-
ing the control wheel.
• Please define if you want to configure the device parameters
(”UnP1/UnP2”) or the channel parameters (”ChAn”).
All the settings that are made under “UnP1/UnP2” will be applied
to the entire device. All settings that are made under “ChAn” will
be applied to the single channels of the device.
• You can individually adjust the line-up time/follow-up time, eco
temperatures, intervals etc. according to the following table.