User manual
43
Start-up
6.4.3 Adding a new floor heating actuator
To add a new floor heating actuator to the system or to the existing de-
vices, please proceed as follows:
• First pair the new floor heating actuator with an existing one.
Activate the pairing mode of the existing floor heating actuator.
Therefore, press and hold down the system button (A) for at least
4 seconds.
• Activate the pairing mode of the new floor heating actuator. Press
and hold down the system button (A) for at least 4 seconds.
The device LED (A) lights up green to indicate that pairing has
been successful. If pairing failed, the device LED (A) lights up red.
Please try again.
• You can add the new floor heating actuator to other devices such
as the wall thermostat or the Multi IO Box. Simply activate the
pairing mode of the floor heating actuator first and of the device
you want to pair afterwards. For further information, please refer
to the user manual of the corresponding device.
6.4.4 Teaching-in to the Homematic IP Access Point
First set up your Homematic IP Access Point via the HomematicIP
app to enable operation of other Homematic IP devices within
your system. For further information, please refer to the operating
manual of the Access Point.