User manual

42
Start-up
til the LED quickly starts flashing orange (see fig. 7). The pairing
mode of the selected channel remains activated for 3 minutes.
• Press and hold down the system button of the wall thermostat
for at least 4 seconds to activate the pairing mode. The device
LED flashes orange.
The device LED (A) lights up green to indicate that pairing has been suc-
cessful.
If pairing failed, the device LED (A) lights up red. Please try again.
6.4.2 Pairing with a Homematic IP Multi IO Box
If you want to pair the floor heating actuator with a Homematic IP Multi
IO Box, the pairing mode of both devices has to be activated first. To do
this, proceed as follows:
• Briefly press the select button (B) until the LEDs of all channels
light up green (see fig. 7).
• Press and hold down the system button (A) for 4 seconds until
the LED quickly starts flashing orange (see fig. 7). Pairing mode
remains activated for 3 minutes.
• Press and hold down the system button of the Multi IO Box for
at least 4 seconds to activate the pairing mode. The device LED
flashes orange.
The device LED (A) lights up green to indicate that pairing has been
successful.
If pairing failed, the device LED (A) lights up red. Please try again.